Safeguarding Golf Courses

…continue from article in December 2017 issue…Safeguarding Golf Courses:

The following points encompass the various protection measures required for the different facilities of a golf course.

Protection for shelters

The purpose of shelters on golf courses is not only to protect golfers from storms and rain, but also from lightning interference. An external lightning protection system, in combination with feasible measures to reduce inadmissibly high step and touch potentials at the entrance and in the shelter, are required in case of a lightning strike. Therefore, shelters should not be installed at exposed locations such as on hills, and at the edge of a forest beneath isolated trees.

Protection for clubhouses

The power supply feeder cable to the main low-voltage distribution board is often located in the basement of the clubhouse, together with different sub-distribution boards supplying power to the restaurants, halfway house, offices, shops, and other detached buildings. Regardless of whether an external lightning protection system exists, a type 1 combined arrester should be installed in the main low-voltage distribution board to prevent potentially damaging lightning currents entering through the power supply feeder cable. In addition, the sub-distribution boards should be equipped with type 2 surge arresters. Telephone and data / internet access (Uk0 lines) usually have a dedicated service room in a clubhouse, and this is where a type 1 combined arrester for IT equipment is installed for the Uk0 lines near the entrance point into the building.

Office communication and RFID systems for ball machines, access control and the rental of golf carts play an important function. Thus, the network card should be protected by a surge arrester for LAN connections and the power supply by a type 3 surge arrester. However, it is equally important to protect the protective circuit for the transmit / receiver antenna of the RFID system or for the TV and radio satellite antenna as well, near the entrance point into the building.

Caddy/ trolley shed with integrated driving range

Measures to avoid inadmissibly high step and touch voltages in case of lightning interference are imperative, particularly in the case of highly frequented entrances and shelter areas. To this end, numerous measures can be employed, for example keeping a surface resistance ≥ 100 kΩ within a limited protective area of three metres around the down conductor (e.g. five cm asphalt). As described above, lightning equipotential bonding has to be implemented for the different systems directly at the entrance point into the building and, if necessary (depending on the results of the risk analysis), further surge protection measures upstream of the terminal device should be provided.

Moreover, the same protection measures as for the clubhouse or the caddy / trolley shed must be taken for the golf cart parking garage and the cart shed.

Protecting the irrigation system

Water is mostly pumped from reservoirs, with pumps that are installed in underground ducts, but controlled and monitored from a service station. The pressurised water pipe runs throughout the entire golf course and the sprinkler systems that are supplied by these pipes maintain the grass and plants. The water flow is controlled through magnetic valves that are installed either directly at the sprinkler or in ground level boxes. In addition, the magnetic valves that activate the sprinklers are controlled by decoders, while the data transmission and power supply for the valves is provided by a two-wire ring conductor. The conductor and the magnetic valves provide the highest risk in terms of surges and, therefore corresponding surge protective devices are installed on the two-wire ring conductor at intervals not exceeding 150m.

Protection for the service station

Lightning equipotential bonding has to be implemented at the entry point into the service station for the pressurised water pipes, the two-wire ring conductor, the IT and the power supply feeder cable and the pump line. Also, it depends on the building size as to whether further surge protection measures are necessary for the internal conductors upstream of the corresponding control systems, as lightning and surge protection have to be individually adjusted to the natural and structural conditions.

To view more information on DEHN click here.

Related articles

Growthpoint to complete a city block of green buildings with its latest

Growthpoint Properties is investing R117.3 million in a new green office development, dubbed The Boulevard, in its latest investment in the Parkside precinct of Umhlanga New Town Centre. Construction on phase one of the building, which represents 5,441sqm of GLA, began in November 2014 and is targeted to be complete in March 2016.The potential bulk […]

Blok Raw pilots 80/20 Development Model

Cape Town urban property developers, Blok, recently announced their latest project, and product launch for 2017 – Blok Raw. This new product by Blok is aimed at introducing a new range of urban homes that target a new price band and new locations within Cape Town’s growing urban centre. Cape Town urban property developers, Blok, […]